Demand is picking up in the global long steel products market after the holidays and it will be even better once the weather becomes warmer in the northern hemisphere. It seems the market is getting back to normal. Section 232 is practically over. General demand is strengthening with the pandemic possibly coming to an end. Bottlenecks seem to be easing somewhat, such as breakbulk freight rates, which have returned to more normal levels. International trade has resumed, bringing confidence to the market. Covid restrictions are being removed. At some point, automakers’ chip shortages will come to an end and this will boost car manufacturing. Market players are looking forward to seeing how raw material prices will settle this week after the Chinese holiday, though the situation so far seems to be positive.

Integrated mills still hold an advantage over their EAF-based counterparts

Steel consumption is still excellent around the world, while the ferrous scrap market has strengthened since the New Year. Input costs for both integrated and EAF-based mills have increased in a similar fashion. However, the advantage still lies with the integrated mills. The relatively high prices for ferrous scrap, along with increasing prices for non-ferrous scrap, are expected to keep the flow of obsolete scrap at elevated levels. Raw material demand is increasing and is expected to drive costs everywhere, along with energy, with EU steel producers contributing significantly to this increasing raw material demand.

Steel producers start announcing green initiatives

Global attention is shifting to steel producers announcing green initiatives, and so now we are all on a three to four-year road to change. Green changes are primarily for local and somewhat regional markets.

Spread between rebar and hot rolled flats mostly returns to historical normal level

The spread between reinforcing bar and hot rolled steel sheet in coil prices is returning to the historical normal level of less than $100/ton in every region, except the US and Canada.

Energy costs remain biggest issue facing producers

Energy is still the biggest issue nowadays facing producers and costs are double compared to the previous year with energy prices reaching all-time record high levels. Costs of raw material will also be another item to deal with. The geopolitical situation is also unstable.

Demand reasonable for EU mills, supported by mild winter weather

Demand is reasonable for EU mills as there are some serious projects in the Mediterranean region. The extremely mild winter in Europe has not interrupted construction yet. All yards are running at 100 percent and mills are nicely booked with orders. Building companies are still trying to push cut and benders down with prices, but the resistance of more and more benders gives hope that bending prices will rise very shortly. Almost every EU market is performing well, and imports are more and more regulated or are not available. Buyers have almost no option. International demand is also either going up or is strong at least, despite the winter season.

Prices soften in US, contrary to global trends

However, the situation is very different in the US from that in the rest of the world. While the rest of the world is experiencing price increases, prices in the US are still softening. Though the US market is coming from much higher prices, the further softening of prices is confusing. Demand is still strong, but the fear of further price reductions keeps distributors from making future commitments. After the EU, the lifting of the Section 232 measures from Japan may not help expectations. However, if the reduced quotas are also applied to Japan as was done in the case of the EU, the effect may be minimal. The US-EU agreement on the removal of tariffs has strengthened EU demand, though it has been a slight negative for US producers during the past month. Expectations in the US are for price stabilization soon and slow price increases to follow due to the inevitable high inflation with low interest rates.

China to produce less steel in 2022, good news for other producers

China has stopped increasing steel production and Beijing’s policy is to produce 100-150 million tons less steel in 2022 than in 2021. Steel demand is still strong in China and exports are not of real interest to them. Chinese steel exports are firmly below six million tons per month. Furthermore, the Chinese government seems to be proposing more infrastructure investments. If China does not produce as much as it did in 2021 and if exports do not increase, then all other suppliers will have the chance to export to Southeast Asian and Far Eastern markets as well. Another major positive is that, if less steel is produced, it will create a mini boom in import demand from mainland China. Also, China’s stimulus in December brought production back in line after the Evergrande debacle, which boosted sentiment.

Levels of competition are reasonable, Turkish mills struggle to compete in Asia

The levels of competition in the market are reasonable. The competition in the reinforcing bar segment is between Asian and Gulf countries as it seems that Turkish mills have difficulty competing at the buying prices seen in Asia.

Outlook very good for an overall strong market

The current status of the market can be described as very stable and strong, perhaps with the only exception of the US for the time being. The outlook is very good and satisfactory.

DO YOU AGREE OR DISAGREE?

PLEASE LEAVE A COMMENT AND SHARE YOUR OPINION WITH US

The outlook for the global long steel products market differs for the scrap industry, the steel producing industry and for steel consumers. The market can be described as generally unstable as there is still a lot of uncertainty and even a tweet may turn a lot of things upside down. We are going through a tough period particularly for BOF-based producers, especially due to increasing raw material costs. There have already been closures and threats of potential closures of several BOFs in Brazil, the
US, Scotland, China, and perhaps even elsewhere. A similar tough period was observed back in 2016, but it was not long-lasting. It seems as if the only way out is to slow down and stop inefficient facilities.

Fundamentals unlikely to support higher scrap prices, supply and demand balanced for billet

Ferrous scrap prices are also picking up, but are not expected to stay where they are now since the fundamentals do not support higher levels. Pig iron prices have seen a downward adjustment to match low residual scrap, which has not made any real gains. Overall, in the market there is an excess supply of slabs, while for billets supply and demand are balanced.

Supply increases in US amid unchanged demand

Demand in the US market for long steel products has not changed, but supply, especially from domestic mills, seems to be
increasing, thus putting pressure on prices. Domestic mills face very little pressure from imports, but, ironically, they are racing against each other to offer deals to even small buyers. On the other hand, US mills are trying to increase their HRC prices, which were unusually low. Of course, the main factor must be the closure of US Steel’s blast furnace-based mills, which have had a hard time competing while using very expensive iron ore.

Canada soon to be number one exporter to US, Mexico more cautious

Canadian mills are now offering to the US with zero duty and will soon gain their number one position as the largest exporter to the US. Mexico has made inroads in the US market, but is cautious as it seeks to avoid further antidumping action on its main products.

Very low demand in South America due to lack of infrastructure investment

The situation in the South American market is pretty much the same as last month. There was a small growth in reinforcing bar consumption in the first five months of this year, but general demand is still very low due to the lack of infrastructure investment. The rebar price level is low when one considers that the iron ore price has hit $117/mt CFR. Integrated mills have no margin to export. The only business opportunities are within Latin America, where the freight cost is less expensive.

Turkish mills’ export opportunities are limited

The EU quotas are almost used up for long steel product exports from Turkey, meaning there will not be any more Turkish sales to the EU market for a year. As a result, the supply-and-demand balance will not be in better shape than it is today for the Turkish mills.

EU market unusually quiet, domestic mills protect their margins, EUROFER not happy

The EU market is very quiet, which is very unusual for this time of the year. EU mills have been trying to move prices upwards but in vain. However, they have not been forced to reduce prices in line with developments in the scrap market and, as a result, have very good profit margins. However, EUROFER is complaining that the EU steel industry is suffering and is thus asking for further measures, which will probably make things even worse for the market. Under such circumstances, it will be very difficult to commit to any international transactions. Subsequently, manufacturing in Europe will even be harder due ot the lack of visibility, which eventually will cause considerable damage to downstream industry. Such actions by the EU have already started eroding common values, i.e., open markets, free trade, etc. EU member states may soon start accusing each other due to the inevitable consequences.

HRC prices in US prove that protectionism is not the solution

It has already been proved that protectionism is not the solution, as prices of HRC in the US are lower than in many other markets nowadays. Free and fair market rules have to be followed. There are already other ways and means to fight unfair trade practices.

No resolution in sight in US disputes with China and Iran

We still have no resolution to the US-China trade war. China is not giving in and the US has no reason to do so. Iran as an important steel producer and there is also no resolution in sight in its case. While there has been some positive sentiment after the G20 summit in Osaka, there is not much confidence because of past behaviours and sudden changes in the political arena.

Iron ore prices soar 18 percent in June, causing cuts in BOF outputs, shift to EAFs

Iron ore pricing soared by 18 percent in June on the back of strong demand and supply disruptions. Some idling of blast furnace production will mean production shifting toward scrap-based electric arc furnaces, which are extending their order books. The production cuts announced by many BOFs in the market will help bring balance to supply and demand.

Exports remain under control in China which shows increased demand for billet imports

Internal consumption in China has so far continued to keep exports under control. Any real or prolonged downturn in China will certainly change the direction of the iron ore market trend. Demand for billet imports is increasing in the Chinese market due to the high domestic production costs. The risk of China exporting steel products is absent, which helps support a balance between supply and demand. On the contrary, China is becoming a destination for semi-finished products. Going forward, we can expect continued investment in the electric arc furnace route in China.

Intense competition within regions, few markets left for exporters

Competition in regional markets is intense, but there is much less competition from deep sea sources due to protectionism. The lack of consumption pushes competition higher. There are very few markets left for exporters.

Demand in Western markets foreseen to remain slow

Demand in Western markets is expected to stay slow for the short term, but we might expect the markets to firm up during the last quarter of this year due to production costs and the anticipated slowdown in production.

Summer demand for scrap expected to be decent, with cheap prices compared to iron ore

As for raw materials, the summer will likely see some decent demand for scrap, which will mean stable pricing. The iron ore to scrap ratio is at a low point. In this respect, scrap looks cheap. The summer period in the European market will draw down scrap availability.

Foggy outlook for next quarter in an unstable market

The activity in the global long steel products market is expected to be slower than usual during the summer. In general, the market is unstable and the outlook for the next quarter is foggy.

DO YOU AGREE OR DISAGREE?

PLEASE LEAVE A COMMENT AND SHARE YOUR OPINION WITH US